Yada Backup Camera Spécifications télécharger pdf (Page 8)

16. Once license plate and Camera are secure, you can adjust the vertical angle of the Camera to your

specic need.

17. As a last check, note the position of the view from the Camera when you place the vehicle in reverse.

Adjust the angle of the Camera as necessary to achieve the best rear view.

WARNING:

Do not attach the 12/24V Direct Power Adapter to the Hardwire Adapter at any time. Only one power

option can be used with the Camera.

DIESEL INSTRUCTION:

Temporarily connect the Camera following the wiring instructions above. Then check the Camera image

for rolling lines with vehicle running. If there are no rolling lines, permanently install the components

and wiring. If rolling lines occur you will need to run a power wire directly to the battery post instead of

using the reverse lights. Then the power line will need to be cut and run to a switch near the driver so the

Camera can be switched on/o. Without a switch the Camera would drain the battery and possibly burn

out the Camera. Be sure to use a fuse when connecting to the battery post.

12V/24V Power

Adapter for Camera

Hardwire cable

for Camera

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Yada Backup Camera Spécifications Page 8