Yada Backup Camera Spécifications télécharger pdf (Page 15)

Follow the steps below to pair your YD-V43 with your mobile phone:

• Power ON the device

• Press and hold M for 2 seconds

• Screen will indicate Pairing Mode

NOTE: YD-V43 is now in pairing mode

• Activate the Bluetooth® settings of your mobile phone

NOTE: The following steps are general procedure; to access Bluetooth® Menu for your mobile phone,

please refer to your phone user manual.

• Select SET-UP or CONNECT from your mobile phone menu

• Find and select OPTION to discover Bluetooth® devices; establishing a connection may take several

minutes

• If found, phone display should indicate YD-V43 device was detected or Select “YD-V43” from the list

• Phone should give you a prompt asking if you want to pair the device

• Select OK or ACCEPT and wait for prompt to enter passkey or PIN

• Enter the code 0000

• Select “OK” to pair and connect the YD-V43 and the handset

• When pairing is complete, the YD-V43’s LCD will show Connected

(Phone’s ID)

NOTE: The YD-V43 can pair with more than one phone, however it can only connect to one phone at a

time. If you wish to pair to a second phone, disable or turn OFF Bluetooth® on the phone already paired.

NOTE: If the YD-V43 and mobile handset did not successfully pair, follow the steps below to retry

pairing:

• Turn the YD-V43 OFF & ON

• Turn OFF all other Bluetooth® devices before starting the pairing process

• Repeat the pairing instructions from the beginning

To Link YD-V43 to your mobile phone after pairing:

• Press of your YD-V43 or

• Establishing the connection via your mobile phone

NOTE: Make sure Bluetooth® has been activated on your mobile phone before you press �

(Please refer to your mobile’s operation manual about connecting Bluetooth® devices)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Pas de commentaire

Yada Backup Camera Spécifications Page 15